Need Help with GPU Passthrough and Driver Installation on Hackintosh via Proxmox VE

Hi everyone,

I’ve successfully installed my first Hackintosh on Proxmox VE by following the luchina-gabriel/OSX-PROXMOX guide. However, I encountered an issue around the 21:50 mark in his video where he uses an RX6900XT ROM. It seems like he manually added the driver for his GPU, but I couldn’t confirm since the video is in Portuguese and the guide is somewhat outdated.

Here’s what I’ve done so far:

1. Installation: Followed the OSX Proxmox guide to set up the Hackintosh. However, I got a bit lost around the 21:50 mark in the video, where the creator mentions a RX6900XT.rom file. I think he manually added the driver for his GPU, but I'm not sure since I don't understand Portuguese (and the guide is quite old).
2. GPU Passthrough: Instead of using the RX6900XT ROM as shown in the video, I followed another guide on GPU passthrough.
3. Current Status: The Hackintosh detects my GPU, but I’m unsure if the passthrough was done correctly.

Questions:

• Driver Installation: Do I need to install additional drivers for the RX6600 on my Hackintosh?
• Passthrough Verification: How can I verify that the GPU passthrough was done correctly?
• WiFi and Bluetooth: I’m planning to install the AX3000 for WiFi and Bluetooth. Any recommendations or tips for that setup?

My specs:

• Proxmox VE Version: 8.2
• Hackintosh macOS Version: Monterey
• Hardware Specs:
  • HP Z620
  • GPU: RX 6600
  • WiFi Card: AX3000 (soon to be added)
  • CPU: Xeon E5-2690 v2 x2

Any guidance or updated resources would be greatly appreciated!

Thanks in advance!