Hardware:
CPU: i5-10600k
GPU: igpu (for now notes below)
RAM: Nemix 2x8gb DDR4 2400 (Samsung chips, defaults to 2667)
Motherboard model: Gigabyte H470M DS3H
Screen(s) Number: 1 (for now)
Screen(s) Resolution: 1920x1080
Audio Codec: intelmausi
Ethernet Card: intel gbe
Wifi/BT Card: (if available) N/A
What guide/tool I followed: https://Dortania.github.io/
What part I got an issue with: This has, in fact, been a nightmare. This is my 4th personal Hackintosh, and even the laptop was easier than this. 1st Issue, No matter what I try, versions of OpenCore from 5.6 to 7.3, all sorts of different settings... the USB Installer will NOT show up. So... used VM to install Success' href='/2020/12/install-macos-catalina-on-supported-pc.html'>Catalina to NVME, USB contains Big Sur currently... neither of those matter. Limiting to the Success' href='/2020/12/install-macos-catalina-on-supported-pc.html'>Catalina install as 7.3 can see it... attempting to boot yields a very quick panic. OpenCore log is incomplete a comparison of the screenshot and log show they stopped at different places. I have tried following every troubleshooting step straight down the list on Dortania and got nada. Most of the recommendations do not even make a change to where it fails, some fail earlier. https://imgur.com/Hj5C1po
What files/config I am using: https://i.imgur.com/x7SVD9k.png
https://drive.google.com/drive/folders/1C1bJx4Eqm62RN7h4qr95M0LKVP9QmPMn?usp=sharing note* apparently the system clock is off on this system... logs are from about 6-7 hours in the future.
Extra Info: Doesn't matter for now, but intent with system is to setup as simple a/v system running qlab. I have done this 3 times before, all still working systems. Plan is to add 2x AMD R5 340x and maybe a Blackmagic Monitor for video outs.
Post a Comment