Good morning,
I am opening this thread as I am now desperate. I think I've read all possible posts from Tonymacx86 and reddit but wasn't able to make it work...
I decided to open a thread here as no one is helping in Tonymacx86 ... Hopefully the reddit community can..
- Motherboard: Asus Prime B360M-A
- CPU: I5 9400F
- GPU: Sapphire RX 5500 XT Nitro+
- Ram: Corsair Vengeance 2x8G
I've followed "UniBeast" method to flash my 16GB Usb2.0 pendrive. I've tried different combinations of config.plist and kexts (USBInjectAll.kext, USBPorts.kext, ...).
Most important parameter I understood I had to configure in the config.plist for the graphics was "agdpmod=pikera" which I did. But the system keeps rebooting when trying to launch clover...(see image attached)
Tried different USB ports but all same...
I bought specifically this 5500xt as it was referred as working in Success' href='/2020/12/install-macos-catalina-on-supported-pc.html'>Catalina by community but I am starting to think it is maybe my motherboard?
Below my EFI:
https://www.dropbox.com/s/gkuk6eo7ogv0n21/EFI.zip?dl=0
Please, help me to have this working. I am ok to go for Success' href='/2020/12/install-macos-mojave-on-supported-pc.html'>Mojave but I think this GPU is only supported since Success' href='/2020/12/install-macos-catalina-on-supported-pc.html'>Catalina (navy support).
Post a Comment