I've been trying the last few days to get my first hackintosh working with little luck. I'm following the Vanilla Intel guide on the sidebar. I tried Clover r5103 which I was able to get to the Apple logo and progress bar, but it got stuck at 100%.
I've now tried r5107 but I can't get past the following screen in verbose mode. (without verbose it gets stuck on a black screen). I'm using the command line to create the USB from the MacOS application and then the clover bootloader with UEFI settings selected.
Picture of the screen I'm stuck at: https://imgur.com/kbseGCZ
Here's my hardware and configuration.
| Motherboard | MSI Z78i (v1.9 bios) |
|---|---|
| CPU | Pentium G3258 |
| RAM | 2x 8GB HyperX Fury DDR3 @ 1800mhz |
| PSU | 450w Corsair CX450 |
| GPU | Sapphire RX 570 Pulse ITX Graphics Card (4GB) |
| BIOS Settings | Copied these (very similar mobo): https://mackonsti.wordpress.com/2016/02/05/setup-msi-z97i-ac-motherboard-os-x/ |
Kexts:
- GenericUSBXHCI.kext
- Lilu.kext
- RealtekRTL8111.kext
- SMCProcessor.kext
- SMCSuperIO.kext
- USBInjectAll.kext
- VirtualSMC.kext
- WhateverGreen.kext
When installing Clover I also selected the vbox HFS driver (it wouldn't see the install without it).
My config.plist is pretty much the default apart from I have the Fake CPUID set to 0x0306C3 to allow my Pentium to work as well as Kernel PM checked (for my motherboard).
Any help would be greatly appreciated, I'm not quite sure what else I can check/do from here :(
[link] [comments]
Post a Comment