I've tried a thousand different things at this point and can't seem to get the installer to show up. I boot from the USB and then boot the install media from Clover but after a couple minutes the screen just goes black. Based on what I've read it seems to be a framebuffer issue but I can't seem to find where I'm going wrong with that.
Hardware is here: https://pcpartpicker.com/list/fMWXL2
BIOS options are
Advanced \ CPU Configuration → Intel Virtualization Technology : Enabled
Advanced \ Chipset Configuration → Vt-d : Disabled
Advanced \ Storage Configuration → Sata Mode Selection: AHCI
Advanced \ USB Configuration → Legacy USB Support : Enabled
Advanced \ USB Configuration → XHCI Hand-off : Enabled
Security \ Secure Boot → Secure Boot: Disabled
Boot → Fast Boot: Disabled
Boot → Boot From Onboard LAN: Disabled
config.plist is here: https://www.dropbox.com/s/b3hknuvze2icwjn/config.plist?dl=0
I used https://cloudclovereditor.altervista.org/cce/index.php to create the config.plist following that section of the internet install guide.
EDIT: I'm using a DVI cable from my motherboard to my monitor.
[link] [comments]
Post a Comment