Hi, everyone!
I'll start at the end on this one. My end goal is to get my graphics card working with OS X. I am using an AMD 7870 Eyefinity 6 on a GA Z77-DS3H motherboard with an i7 3770k processor.
I have tried looking through kext files to add a Device ID, but only ATI7000Controller.kext had Device ID strings. That one included 0x68181002 in the strings section, so I don' t think that should be the problem. I also checked ATIFramebuffer.kext and ATISupport.kext, but neither of them had Device ID strings.
I've tried Chameleon, Chimera, and Clover, but none of them work. Chameleon and Chimera, I could only get mirrored screens working in Safe Mode, but nothing working otherwise. Under these conditions, it would not recognize my graphics card as anything other than AMD, it does not detect any kexts, and it tells me I have 3MB of vram. With Clover, I can get it to boot, but it gives me either a blank white or black screen, depending on settings. I can still operate volume controls and make some system sounds, but that's where it ends. One time, I did get Clover to boot to white screens with a cursor that went from one screen to the other, but I have been unable to reproduce this.
If I run on internal graphics, all of them boot fine, except Clover, which usually hangs somewhere around
I have gotten Clover to boot in safe mode, but it would be nice to move past that.
I'm going to repost this across several forums, just to try to get any kind of answer. I'm not spamming, I'm just at the end of my proverbial rope on this issue.
I'll start at the end on this one. My end goal is to get my graphics card working with OS X. I am using an AMD 7870 Eyefinity 6 on a GA Z77-DS3H motherboard with an i7 3770k processor.
I have tried looking through kext files to add a Device ID, but only ATI7000Controller.kext had Device ID strings. That one included 0x68181002 in the strings section, so I don' t think that should be the problem. I also checked ATIFramebuffer.kext and ATISupport.kext, but neither of them had Device ID strings.
I've tried Chameleon, Chimera, and Clover, but none of them work. Chameleon and Chimera, I could only get mirrored screens working in Safe Mode, but nothing working otherwise. Under these conditions, it would not recognize my graphics card as anything other than AMD, it does not detect any kexts, and it tells me I have 3MB of vram. With Clover, I can get it to boot, but it gives me either a blank white or black screen, depending on settings. I can still operate volume controls and make some system sounds, but that's where it ends. One time, I did get Clover to boot to white screens with a cursor that went from one screen to the other, but I have been unable to reproduce this.
If I run on internal graphics, all of them boot fine, except Clover, which usually hangs somewhere around
Code:
IO80211Controller::dataLinkLayerAttachComplete(): adding AppleEFINVRAM notification
IO80211Interface::efiNVRAMPublished():I have gotten Clover to boot in safe mode, but it would be nice to move past that.
I'm going to repost this across several forums, just to try to get any kind of answer. I'm not spamming, I'm just at the end of my proverbial rope on this issue.
source
Post a Comment